Curious to know what does mead tastes like is to consider its parts. Honey, fig, wine, and yeast all infused into one big brew. Infuse a batch as an extra offering at your beer garden or you might just want to impress friends with homemade fig mead, aka honey fig wine that is literally in a category of its own.
You Need Fig Mead
If you’ve never heard of mead before, but like your wine on the fruity side, you’re going to enjoy this. Unlike wine made from grapes, mead is made from fermenting water with honey and yeast, often flavored with fruit. You’ll be fascinated to learn mead has a niche following of devotees who brew their own or stock up on all the different kinds available.
Honey Fig Wine with Ancient Roots
Mead has ancient roots but has recently begun rising in prominence and popularity. Chaucer includes mead in his Canterbury Tales. Mead has been around for 7000 years and was popular among the Vikings, Mayans, Egyptians, Greeks, and Romans.*
Making fig mead from scratch isn’t hard but does require patience. With a few tools and ingredients you can stock your happy hour with this honey fig wine.
Types of Figs to Make Mead
For the fig mead recipe, both California Dried Mission and Golden Figs are used as they both bring different characteristics to the final brew. Golden Figs add a subtle sweetness and nuttiness whereas Mission Figs bring a familiar flavor from childhood with a more intense depth of sweetness. Feel free to use either Sun-Maid or Orchard Choice.
Feed Your Mead: All about Yeast
NOTE: All baker’s yeast are the same type of yeast, but because all of them are different strains they will have different flavors. Just like two dogs are the same breed but have very different personalities. Any baker’s yeast will work, but Fleishmann’s strain has been used by amateur mead makers for years, the “bready” flavors balance the sweetness, especially since there aren’t any grains involved. Ancient mead was made with baker’s yeast because that’s what they had. If someone wants to experiment with different strains, that’s totally fine it will still work. If someone wants to go to a homebrew supply, they can also try a champagne yeast which will work really well also.
Perhaps you’ve just always been curious about mead—in any case, you’ve found the right fig mead recipe for beginners. It’s super easy, no special equipment required, and (to the horror of brewers everywhere) regular Fleishman’s baker’s yeast does an excellent job of standing in for brewing yeast. You just need a few things you can pick up at your local grocery store and you’re all set to start your fermentation adventure.
What does fig wine taste like?
What does mead taste like: it’s a bit sweet but also yeasty with floral fruit notes from the figs. As it ages the flavor will mellow.
Fig Mead
Equipment
- Clean gallon jug (glass one or the spring water jug will work as well)
- Balloon
- Sealable glass jars or bottles
Ingredients
- 1 gallon spring water , room temperature
- 1 pound Orchard Choice or Sun-Maid California Figs , cut into quarters
- 2 1/2 pounds raw honey
- 1 packet (2 1/4 tsp) Fleishman's Yeast
Instructions
- Add the honey and water to a pot, heat just until the honey and water have combined. No need to boil. Honey is the “food” the yeast needs to ferment, most of this will be eaten up during fermentation and the mead will be rather dry. For a sweeter mead, add another half a pound of honey.(Tip: Do not use tap water as there are too many possible contaminants, even if you have a home filtration system. It’s best to use store-bought water for the best taste, especially if you are new to mead making.)
- Add the quartered figs to the sanitized jug. Pour in the honey water, make sure the water is below 110°F, add the yeast and seal. Shake vigorously to combine, remove the seal.(Tip: Sanitizing is key! Make sure all your equipment is sanitized to ensure you don’t have any unwanted yeast or bacteria in your mead.)
- Add a balloon on top of the jug, poke a hole or two in the top with a clean pin or needle. This will act as an airlock. It will allow the air to escape during fermentation but not allow contaminants in. If you leave the jug sealed, the pressure will cause it to explode, if you don’t cover the top, yeast, and bacteria will contaminate your mead. A balloon with a pinhole in the top allows the air created during fermentation to escape but keeps out any unwanted bacteria.
- After 2 to 24 hours the balloon will inflate, and this is how you know fermentation has taken place. If the balloon doesn’t inflate at all it likely means the yeast isn’t active and you should start over.
- Place in a cool (but not cold) dark place, like a cabinet or closet. Keep away from direct sunlight. Check on it daily to make sure the balloon hasn’t popped off.
- After about three weeks the balloon will become limp and this is how you know primary fermentation is over. Gently pour the mixture into a new clean jug (or a clean large bowl so you can clean and refill the one you are already using). Remove the figs and any sediment that has settled to the bottom of the jug. Add another balloon with a hole poked into the top.
- Age your mead. At this point, the mead is drinkable but it will take another few months to make it really tasty and clear. You can age it in a cool closet or your refrigerator, these different environments will produce different flavors.
- Bottle your mead into clean and sanitized jugs with air sealing tops. You can continue to age your mead for months or even years to develop the flavors you want. Make sure to keep it out of direct sunlight.